IND-02 · INDUSTRIAL ELECTRONICS
Industrial automation and robotics
We diagnose PLC, HMI, robot-controller and motor-drive boards with power, communication or I/O faults. Send the part number and machine symptoms before removal. Parts, firmware and available test fixtures determine whether we can repair and verify the unit.
Equipment we assess
- PLC and HMI boards
- Robot controllers and teach-pendant boards
- Servo, motor-drive and I/O electronics
- Embedded controllers and legacy machine boards
Faults we investigate
- Dead power supplies and failed power stages
- Communication and I/O faults
- Heat, contamination and corrosion damage
- Intermittent operation and obsolete components
Diagnosis and repair work
- Power-rail and short-circuit isolation
- Component and connector replacement
- Microscope inspection and controlled rework
- Board-level functional checks where a safe fixture is available
IMPORTANT LIMITS
Board repair is one part of the wider responsibility.
- 01Machine-level commissioning is not included
- 02Safety PLCs and protective systems require authorized validation
- 03Encrypted firmware, proprietary pairing or unavailable test fixtures can limit verification
REQUEST A TECHNICAL ASSESSMENT
Information to include in your enquiry
Include the exact model or part number, the symptoms and previous repair history. The details below help us decide what equipment we need for diagnosis and testing.
Send manufacturer, exact part number, machine function, fault codes, photographs and whether an identical working unit is available for comparison.
Use email for a detailed description and photos, or WhatsApp for a short question before shipping.
FAQ
Questions about this service
Can you repair obsolete industrial boards?
We assess obsolete boards when the exact part number, symptoms and test requirements are known. Available components, firmware access and physical damage determine whether repair is possible.
Do you need the whole machine?
Usually not. We first determine whether the board, power supply, panel or a small test assembly is needed.
Can you certify a repaired safety controller?
No. Any safety-related controller must be validated and returned to service by the responsible authorized party.
